DEED-MAPPER-USERS-L Archives

Archiver > DEED-MAPPER-USERS > 2003-08 > 1061431733


From: "Nancy Upshaw" <>
Subject: RE: [DMU] Re: DEED-MAPPER-USERS-D Digest V03 #47
Date: Wed, 20 Aug 2003 22:08:53 -0400
In-Reply-To: <20030819.203150.-781095.2.dadster3@juno.com>


Barry,

You might check to see if for your default settings on your printer you
have "fit to page" set. I have sometimes found that that can cause your
problem to happen. When you go to print from Deedmapper, if you can get
to the Properties before it actually prints (I forget whether you can or
not) to turn that off, it may help. Turning it off inside an application
should not change the default settings for other apps.

-Nancy Upshaw

-----Original Message-----
From: [mailto:]
Sent: Tuesday, August 19, 2003 8:30 PM
To:
Subject: [DMU] Re: DEED-MAPPER-USERS-D Digest V03 #47

Mr. Wilson,

Thanks for the reply regarding the problem with DeedMapper pagination.
I've had this printer for several years and have never had a problem
like
this. It prints everything from e-mail to a DOS version of Quicken
flawlessly. There is nothing to adjust in DeedMapper, as far as I know,
but I do think it is a software issue, not hardware.

You didn't say what you were printing as a test. I was trying to print
the line editor deed descriptions, not the plots. Haven't gotten to that
yet.

Anyway, I've worked around it by send 5 or so deeds to the printer
individually. They que up and print just fine. I find that I prefer
printing in small batches anyway. If there is a paper jamb or something
it's easier to stop the print job and less wasteful.

Thanks,
Barry Clark
Fredericksburg, VA

______________________________

This thread: