TMG-L Archives
Archiver > TMG > 2000-04 > 0956809467
From:
Subject: [TMG-L:] Re: TMG-L: Multiple wives out of sequence.
Date: Thu, 27 Apr 2000 00:24:27 EDT
In a message dated 4/26/2000 5:49:08 PM Eastern Daylight Time,
writes:
> From Person View screen I perform the following actions:
> a) Add husband using 'husband' selection.
> b) Add wife # 1 using 'wife' selection.
> c) Add wife # 2 using 'wife' selection.
>
> On Family View screen, wife #1 is shown as second wife & wife #2 is shown
> as first wife.
Dean,
I also have observed this problem - and in the Tree View also.
On a similiar topic, I asked TMG tech support to address the fact that on the
Family and Tree views, only the date for the primary marriage is shown. All
other multiple marriages show with no date. I find this very poor
(especially since as you point out, the marriages are not shown in sequence).
They said they passed it along to programming for future consideration.
Also I have noticed that since some reports print names in the PO and P1
sequence, it is important to consider whether the male or female is in the PO
position on the marriage entry. (I have really noticed this in the
dependancy chart report when the subject marriage is the start of the chart)
Cal
-----------------------------------------------------------------------------
TMG-L The Internet Mailing List for The Master Genealogist
To unsubscribe: Send an e-mail to with 'UNSUBSCRIBE TMG-L'
or... if you get the digest version: 'UNSUBSCRIBE TMG-L-DIGEST'
-----------------------------------------------------------------------------
This thread: